聚苯乙烯-二氧化硅复合颗粒对铜层的化学机械抛光性能
- 文件大小:838.91KB
- 浏览次数:
- 发布时间:2014-03-18
本资料包含pdf文件1个,下载需要1积分
随着集成电路线宽变窄,要求铜互连表面具有更低的表面粗糙度,对化学机械抛光(CMP)技术提出更高的要求。采用聚苯乙烯(PS)-二氧化硅(SiO2)复合颗粒作为铜层CMP的抛光磨粒,研究出PS―SiO2核壳结构的形成条件,分析新型抛光液体系中各颗粒含量、pH值等因素对Cu抛光效果的影响,通过X射线光电子能谱(XPS)、扫描电镜(SEM)等手段探讨其中的抛光机制和颗粒残留等问题。结果表明:较之PS、SiO2颗粒抛光液,复合颗粒抛光液抛光cu后,获得更大的去除和更好的表面质量,且与抛光过程中摩擦因数的关系相符合。 With the linewidth of Integrated Curcuits (1C) narrower and narrower, the surface of Cu interconnection would be made lower roughness and Chemical Mechanical Polishing(CMP) technology would be more brilliant. Polystyrene( PS)- Silica ( SiO2 ) composite particles as the abrasive in CMP of copper, the preparation condition of the particles was discussed. The influences of two particles concentration in composite particles and pH value in new slurry were analyzed. X-ray photoelectron Spectrometer(XPS) and Scanning Electron Microscope(SEM) were used to study polishing mechanism and particles residual. The results show that the slurry with PS-SiO2 composite particles comparing with PS and SiO2 particles, acquires higher material removal rate and better surface quality in CMP of copper,which is in accordance with the relation of friction coefficient in polishing process.
- 1JT/T 371-1997 水下局部排水二氧化碳保护半自动焊作业规程
- 2庭院景观设计SU模型(版本20)
- 3砼、钢筋、模板工程量计算模板 (经典推荐)
- 4中级职称申报空白表
- 5吉林省建设工程造价咨询服务补充项目收费标准
- 6jt 394-1999 内河高速客船安全航行技术条件
- 7杠杆(一)钻8孔夹具装配图及零件图
- 8常见的设计缺陷100例
- 912#换热站工程施工组织设计
- 1030装载机CAD总图
- 112010年广东省建筑工程计价通则
- 12北京市地铁五号线全套设计施工图纸
- 13BA044工艺规程安排及夹具设计加图纸
- 14HB 7028.22-1994 夹具通用元件压紧件 圆头齿面压块
- 15一大株日本血草3dsmax设计