基于Adams的多连杆机械式压力机动力学分析
- 文件大小:211.39KB
- 浏览次数:
- 发布时间:2014-03-26
本资料包含pdf文件1个,下载需要1积分
针对多连杆机械式压力机,采用模块化方法构建其传动部分数学模型,得到压力机工作机构滑块的运动方程;根据运动方程,利用仿真软件Matlab得出滑块的位移、速度、加速度曲线。用三维软件Soldworks构建传动部分三维模型,应用动力学分析软件Adams对模型进行动力学分析,对比两种结果,得出该结构适用于深拉伸加工工艺,模具在拉伸工作区的冲击很小,满负荷时工作区域长。 A mathematical model of transmission parts of the multi-link mechanical press was established with modularization method.The motion equation of operating mechanism slide block in the mechanical press was obtained.According to the equation,the displacement,velocity and acceleration curves of the slider is acquired with the the simulation software Matlab.Three-dimensional model of the drive section is established by 3D software Soldworks.The dynamics analysis is done with Adams.The conclusion achieved by comparison of the two results indicates that the structure is applied to deep drawing processing technic.
- 1某桑拿水疗店装修设计CAD图纸
- 2高清版质量验收规范务实全书
- 3自制经典车床三维模型SolidWorks设计
- 4JB/T 13355-2017 气焊熔剂
- 5DB33/T 650-2007 车(船)载全球卫星导航定位系统终端与控制中心通信协议
- 6NF A49-147-1980 中文版 钢管 一般用和管道用光端纵向焊接钢管 奥氏体不锈钢 尺寸 交货技术条件
- 7经典塑料蜗杆模具图
- 8一级注册建造师考试试卷-市政公用工程管理与实务模拟试题八套
- 9[广联达]北京某酒店修缮工程结算书
- 10Φ2.2×7米水磨机
- 11205顾客服务加回访记录
- 12MT/T 362-1994 煤矿水中铅的测定方法
- 13精装别墅主卧立面CAD图纸
- 14双轴数控车床SolidWorks设计
- 15GB/T 22154-2008 国际货运代理服务质量要求