美国军用标准-喷丸

本资料包含pdf文件1个，下载需要10积分

美国军用标准-喷丸 INCH-POUND

MIL-S-13165C
7 June 1989
SUPERSEDING
MIL-S-13165B
31 December 1966

MILITARY SPECIFICATION

SHOT PEENING OF METAL PARTS

This specification is approved for use by all Departments and Agencies
of the Department of Defense.

1. SCOPE

1.1 Scope. This specification covers procedure requirements for shot peening of metal parts， to
induce residual compressive stresses in specified surfaces， for the purpose of improving resistance to
fatigue， stress corrosion cracking， and galling (see 6.1).

2. APPLICABLE DOCUMENTS

2.1 Government documents.

2.1.1 Specifications， standards， and handbooks. The following specifications， standards， and
handbooks form a part of this document to the extent specified herein. Unless otherwise specified， the
issues of these documents are those listed in the issue of the Department of Defense Index of Specification
and Standards (DODISS) and supplement thereto， cited in the solicitation (see 6.2).

SPECIFICATIONS

FEDERAL

RR-S-366 - Sieves， Test

MILITARY

MIL-S-851 -Steel Grit， Shot and Cut Wire Shot; and iron Grit and Shot-Blast
Cleaning and Peening
MIL-S-5002 -Surface Treatments and Inorganic Coatings for Metal Surfaces of
Weapon Systems
MIL-G-9954 -Glass Beads， for Cleaning and Peening

Beneficial comments (recommendations， additions， deletions) and any pertinent data which may be of use
in improving this document should be addressed to: Director， US Army Laboratory Command， Materials
Technology Laboratory， ATTN: SLCMT-MEE， Watertown， MA 02172-0001 by using the Standardization
Document Improvement Proposal (DD Form 1426) appearing at the end of this document or by letter.


AMSC N/A AREA MFFP
DISTRIBUTION STATEMENT A Approved for public release; distribution unlimited.