重交沥青装置扩能改造项目论证
- 文件大小:720.21KB
- 浏览次数:
- 发布时间:2017-02-24
本资料包含pdf文件1个,下载需要1积分
某公司重交沥青装置自2003年10月建成投产以来,克服原料性质复杂且供应不足等诸多困难,采用灵活的加工方案,完成各项生产任务,总体上生产运行良好。07年9月随着60×104t/a重油催化裂解装置的建成投产,宝塔灵州石化有限公司重交沥青装置的生产能力已不能满足生产需要。根据远期发展规划,并结合公司实际情况,决定对重交沥青装置进行扩能改造。改造后装置按原油和M100燃料油混合加工设计,加工比例为原油:M100燃料油为=1:4,加工能力达到(90~105)×104t/a,从而与60×104t/a重油催化裂解装置配套,达到物料平衡。
Heavy traffic asphalt plant since October 2003 has been put into operation, to overcome the shortage of raw materials and the complex nature of many difficulties, flexible processing had optioned, many production tasks were completed, the whole production run good. In September 2007 with 600,000 t/a of heavy oil catalytic cracking unit into operation, the state petrochemical company spirit heavy traffic asphalt plant production capacity can not meet the production needs. Development plan under the Group, combined with the company's actual situation, the decision on the heavy traffic asphalt plant for Capacity Expansion. After transformation device by processing crude oil and M100 fuel oil mix design, processing ratio of crude oil: M100 fuel oil was 1: 4, processing capacity of 90-105 t/a to 600,000 t with the equipment necessary, to achieve material balance.
重交沥青装置,扩能改造,物料平衡,heavy traffic asphalt plant,capacity expansion,material balance。
重交沥青装置扩能改造项目论证。
- 1单位工程竣工图登记表
- 2JIS P8119-1998 Paper and board -- Determination of smoothness by Bekk method
- 3浮选柱的发展与应用
- 4预算员岗位-培训
- 502S701砖砌化粪池图集(高清)
- 6挡土墙4600
- 7泗阳悬灌梁施工方案
- 8幕墙工程报价分析表-精
- 9JB/T 10092-2000 磁性调压器
- 10980钢超窄间隙熔化极气体保护焊研究
- 11GA 49-2014 道路交通事故现场图绘制
- 12GB/T 1408.2-2016 绝缘材料 电气强度试验方法 第2部分:对应用直流电压试验的附加要求
- 13QB/T 2798-2010 食品添加剂 杭白菊浸膏
- 14桥梁必备手册
- 15高层建筑悬挑式外脚手架的要点简析