冷冲模
- 文件大小:1.98MB
- 浏览次数:
- 发布时间:2017-03-10
本资料包含doc文件3个、dwg文件1个,下载需要100积分
冷冲模Heat Treatment of Die and Mould Oriented Concurrent Design
LI Xiong,ZHANG Hong-bing,RUAN Xue-yu,LUO Zhong-hua,ZHANG Yan
Traditional die and mould design,mainly by experience or semi-experience,is isolated from manufacturing process.Before the design is finalized,the scheme of die and mould is usually modified time and again,thus some disadvantages come into being,such as long development period,high cost and uncertain practical effect.Due to strong desires for precision,service life,development period and cost,modern die and mould should be designed and manufactured perfectly.Therefore more and more advanced technologies and innovations have been applied,for example,concurrent engineering,agile manufacturing virtual manufacturing,collaborative design,etc.
Heat treatment of die and mould is as important as design,manufacture and assembly because it has a vital effect on manufacture,assembly and service life.Design and manufacture of die and mould have progressed rapidly,but heat treatment lagged seriously behind them.As die and mould industry develops,heat treatment must ensure die and mould there are good state of manufacture,assembly and wear-resistant properties by request. Impertinent heat treatment can influence die and mould manufacturing such as over-hard and-soft and assembly.Traditionally the heat treatment process was made out according to the methods and properties brought forward by designer.This could make the designers of die and mould and heat treatment diverge from each other,for the designers of die and mould could not fully realize heat treatment process and materials properties,and contrarily the designers rarely understood the service environment and designing thought. These divergences will impact the progress of die and mould to a great extent. Accordingly,if the process design of heat treatment is considered in the early designing stage,the aims of shortening development period,reducing cost and stabilizing quality will be achieved and the sublimation of development pattern from serial to concurrent will be realized.
Concurrent engineering takes computer integration system as a carri
- 1SN/T 1045.1-2010 进出口染色纺织品和皮革制品中禁用偶氮染料的测定 第1部分:液相色谱法
- 2DB34/T 476-2004 三元杂交猪生产 养猪场兽医防疫规程
- 3楼梯一平台板配筋cad图
- 4航天长寿命轴承润滑技术
- 510J932 农村中小学校标准设计样图
- 6注册监理工程师初始、变更、延续注册申请申报材料初始复核意见表
- 7幕墙招标全套
- 8JB/T 7601.8-1994 电线电缆专用设备 基本技术要求 第8部分:表面处理
- 9齿轮参数计算表格
- 10龙湖小区高档住宅楼强电设计施工图
- 11DB11/T 1550-2018 残疾人社区康复站服务规范
- 12玻璃钢容器与管道的应用
- 13HG/T 2409-1992 聚氨酯预聚体中异氰酸酯基含量的测定
- 14建筑施工现场临时用电负荷的计算方法
- 15蓝天华门酒店弱电智能化设计施工图纸(定稿)