平板状电流变阀压力差理论与实验分析
- 文件大小:454.8KB
- 浏览次数:
- 发布时间:2014-03-21
本资料包含pdf文件1个,下载需要1积分
利用电流变技术,基于电流变阀的工作机理,设计了单通道平板状电流变阀和双通道平板状电流变阀样机.分析了两种平板状电流变阀压力-流量方程,并通过有限元方法理论分析了平板状电流变阀的强度.在理论分析的基础上,制作了两种平板状电流变阀样机并建立了实验系统,对影响平板状电流变阀性能的关键参数进出口压力差进行了实验研究.实验结果表明,平板状电流变阀的进出口压力差随流量增加而增大,还随着输入电压的提高而线性增大.当电压为110kV、流量为211.2mL/min时,单通道平板状电流变阀进出口压力差达到0.12MPa. Two kinds of flat electrorheological valve (ER-valve) prototypes, single channel and double-channel ER-valve, are designed with electrorheological technology. Pressure-flow equa- tions of the two kinds of flat ER-valves are analyzed, and the intensity of the flat ER-valves is al- so solved by finite element method. Following the theoretical analysis, the two kinds of flat ER- valves and the corresponding experimental system are manufactured. The key parameter, pres- sure difference between entrance and exit affecting ability of flat ER-valves, is experimentally in- vestigated. It shows that pressure difference increases with raising flow and increases linearly with heightened input voltage. The pressure difference of the single-channel ER-valve gets 0.12 MPa as the voltage is 110 kV and flow is 211.2 mL/min.
- 1SY 6279-2016 大型设备吊装安全规程
- 2018普通混凝土现场拌制工艺
- 3GB 1886.242-2016 食品安全国家标准 食品添加剂 甘草酸铵
- 4ZQP23.4脚架
- 5WS 291-2018 麻风病诊断
- 6某尾矿库大坝施工组织设计_secret
- 7建筑电气施工工法(二)
- 8QB 2238-1996 强化营养盐
- 9液压支架试验框架平台SolidWorks设计
- 10托森差速器工作原理解析
- 1102、03浆砌石坝结构图
- 1201-潍坊市人民医院门诊楼施工组织设计(鲁班奖)
- 13山东某书城抗浮锚杆工程施工组织设计
- 142008版公路表格 土建评表6.11.2 导流工程质量检验评定表
- 15焊接要点