大黏度润滑剂油膜形状实验测量
- 文件大小:912.52KB
- 浏览次数:
- 发布时间:2014-03-09
本资料包含pdf文件1个,下载需要1积分
The effects of slide-roll ratio ,applied load and entrainment velocity on the film shape ,central film thickness and minimum film thickness of high-viscosity were studied using multi-beam interferometry. The results show that the central film thickess is experienced the changing process of increased and then decreased for a while, finally increased again along with the increasing of entrainment velocity under pure rolling conditions. The entrainment velocity is gone down gradually as the fall of the central film thickness presented for a while, along with the increasing of the slide-roll ratio from zero,and this fall is disappeared in the vicinity of the slide-roll ratio equal to 2. The central and minimum film thicknesses are hardly depended on the applied load under lower entrainment velocity. The central and minimum film thicknesses are decreased more along with the increasing more of the slide-roll ratio.采用多光束干涉技术,研究滑滚比、载荷及卷吸速度等对大黏度润滑剂油膜形状、中心膜厚及最小膜厚的影响。初步结果显示:纯滚动条件下,随着卷吸速度的增大,中心膜厚经历了增大、暂时下降、然后再上升的变化过程;随着滑滚比从0增大,中心膜厚暂时下降需要的卷吸速度逐渐减小,当滑滚比接近2时,这一现象消失;卷吸速度较小时,中心膜厚及最小膜厚基本不受载荷影响;滑滚比越大,中心膜厚及最小膜厚越小。
- 1双机圆柱齿轮减速器三维模型cad图纸
- 2蓝天郡小区某私人别墅混凝土结构设计施工图纸
- 3机动翻斗车安全操作规程
- 4港池扫测技术报告模板
- 5串口通讯的概念及接口电路
- 62012年全国监理工程师《合同管理》测试题(1-5).doc
- 7清华斯维尔常见问题解答100例
- 8秦沈铁路测量管理规定
- 9VAT阀门、vat真空阀门三维模型SolidWorks设计Sldprt格式
- 10杭州CD1MD型1-10t 钢丝绳电动葫芦外型尺寸参数exb
- 11五次分型模具拉环瓶盖(132穴),五次分型脱模CAD图
- 12钢结构详图设计实例图集[1]
- 13方圆集团_FYGCBZ-T-01_加气混凝土砌块施工技术细则
- 14过滤器接头图纸
- 15辽2015J301 外墙外保温