铜粉对半金属摩擦材料摩擦学性能的影响
- 文件大小:585.11KB
- 浏览次数:
- 发布时间:2014-03-12
本资料包含pdf文件1个,下载需要1积分
Semimetal friction material containing different content of copper powder was prepared by using directly mixed method.Effects of copper prwder content on tribological behavior were studied by using friction tester, morphologies of wear surface were observed, and wear mechanism was analyzed.The results show that by adding copper powder, friction coefficient at medium and high temperature is rising, heat fading and stability of material are improved, wear rate at medium temperature is reduced.When the content of copper powder is 3%, the tribological behavior of semimetal friction material is best.采用直接混合干法生产工艺制备出不同铜粉含量的半金属摩擦材料,用定速式摩擦试验机进行摩擦磨损试验,分析了铜粉含量对半金属摩擦材料摩擦学性能的影响,并通过观察磨损形貌照片分析其磨损机制。结果表明,铜粉能够提高半金属摩擦材料制品在中温以及高温的摩擦系数,能够显著改善材料的抗热衰退性和稳定性,能够降低半金属摩擦材料中温阶段的磨损率。当铜粉质量分数为3%时,半金属摩擦材料的摩擦挚陛能最佳。
- 1GB/T 15101.1-1994 中国对虾养殖 亲虾
- 2广联达三代智能锁修正版本地写锁工具
- 3人行道工序质量评定
- 4店子坝顺流向闸底板(左半梁)弯矩计算
- 5厕所水、电全套CAD图纸
- 6水利建设项目后评价报告编制规程(送审稿)
- 7常用材料重量与比重表
- 8QB/T 4960-2016 制鞋机械 曲肘式胶粘压合机
- 9YD/T 819-1996 数据传输链路和系统的性能分配及限值
- 10续梁桥墩、桩基计算小程序
- 11《危险性较大的分部分项工程安全管理办法》讲解内容
- 12DB11/T 212-2017 园林绿化工程施工及验收规范
- 13DB31/2017-2013 食品安全地方标准 发酵肉制品生产卫生规范
- 14BS EN 10244-1-2009 Steel Wire and Wire Products - Part 1 General Principles
- 15TB/T 2458.14-1993 铁道标准体系表 电气化铁道