微阶梯轴承油膜厚度的特性研究
- 文件大小:352.45KB
- 浏览次数:
- 发布时间:2014-03-21
本资料包含pdf文件1个,下载需要1积分
利用自行开发的微型面接触润滑油膜测量系统,对阶梯轴承的流体动压润滑油膜厚度进行试验测量。试验中以静止的微型阶梯滑块平面和旋转的光学透明圆盘平面形成润滑副,在保持载荷一定的条件下,分别在阶梯滑块和玻璃盘成正的接触楔形角(正倾角)、负的接触楔形角(负倾角)和零接触楔形角(平行)不变的条件下,对油膜厚度-速度曲线进行测量,并与采用经典Reynolds方程得到的数值解进行对比。结果表明:正倾角和平行条件下,在数值变化趋势方面理论计算与试验有良好的一致性;负倾角条件下,数值解与测量值偏差较大。 The film thickness of hydrodynamic lubricant in step bearing was measured by a custom-made test apparatus. In the experiments, the lubricated parallel contact consisted of a micro-slider plane and a transparent glass disc. Under a fixed load, the film thickness at different entrainment speeds was measured at three different inclination between step bear- ing and glass disk, that is plus inclination, negative inclination and parallel. The numerical solutions were got using classi- cal Reynolds control equation, and were compared with the experimental results. The results show that in plus inclination and parallel, experimental results and numerical solutions have a good consistency in the trend of numerical change, while in negative inclination, there is a big deviation between experimental results and numerical solutions.
- 1预埋地脚螺栓及预埋件施工工艺_secret
- 2不锈钢焊接要点及注意事项
- 3GB/T 18527.1-2001 苹果辐照保鲜工艺
- 4XX污水泵房工程施工方案
- 5手术室净化招标文件20100420
- 6联合收割机割禾器的研究及设计(全套设计含CAD图纸通过答辩)
- 7DBJ50-047-2006建筑地基基础设计规范(重庆)
- 85.4.17钢筋混凝土预制桩模板工程检验批质量验收记录
- 9人工分拣钢平台总图
- 10楼梯iges/igs格式
- 115寸指纹识别金属手机proe设计
- 12CJ/T 490-2016 燃气用具连接用金属包覆软管
- 13热膨胀系统图(331B-2)
- 14SJ 1408-1978 3DA101型NPN硅高频大功率三极管
- 15全站仪与 AUTOCAD 软件结合在施工测量中的应用